 |
| 4>>
Channel thermoregulated |
|
|
|
4.1
- SINGLE THERMO-REGULATED BLOCK |
This
device is used to inject into several points in the mould;
it consists in a steel block where are placed injection
runners, which are manteined at a safety temperature of
60-90 C°, thanks to the crossing of a thermoregulated
fluid in a special circuit placed in the platen. The device
is equiped by a set of regulators to check the amount
injected by every nozzle. Injection nozzles are selfadaptable
in height, as to fit better in the moulds. The special
nozzles conformation allows to make up for possible skews
of injection holes. The device, besides to inject into
several points of the same plate, allows to inject in
two work plate at the same time, too.
|
|
| |
4.2
- DOUBLE THERMOREGULATED BLOCK |
| this
device is used to inject into several points in the mould;
it consists in a steel block where are placed injection
runners, which are manteined at a safety temperature of
60-90 C°, thanks to the crossing of a thermoregulated
fluid in a special circuit placed in the platen. The device
is equiped by a set of regulators to check the amount
injected by every nozzle. Injection nozzles are selfadaptable
in height, as to fit better in the moulds. The special
nozzles conformation allows to make up for possible skews
of injection holes.The device, besides to inject into
several points of the same plate, allows to inject in
two work plate at the same time, too. |
|
|
|
